Removing rose from lockset

[NC2]

This is probably a simple question, but I cannot seem to remove a rose/trim from an unbranded (possible Schlage) lock.
It does not have a slot to put a screwdriver in to pop it off, it only has a small hole on the side of the rose.

https://imgur.com/gq6onWI

[ADMIN EDIT: This is what the [image] command needs to display an image file:]
https://i.imgur.com/gq6onWI.jpeg

Using the URL above displays this:



Any help would be greatly appreciated

[Raymond]

Easy problem - easy answer. That lock was put on with a large spanner wrench that came with the lockset. The spanner is just a large "C" shaped curve, with handle, and with a 90 degree tab sticking inward that fits into the hole. Then you just unscrew the trim.

[NC2]

Easy problem - easy answer. That lock was put on with a large spanner wrench that came with the lockset. The spanner is just a large "C" shaped curve, with handle, and with a 90 degree tab sticking inward that fits into the hole. Then you just unscrew the trim.

That was it! Thank you Raymond