Semi Home Made pics

[Jackpot]

aight i took two small flat head screwdrivers... i left one flat on the sides for the tension wrench. and the other one i grinded round for a pick... tell me if you think it will be a good set up?

[Pheniox]

that all depends on how ting the second screwdriver is... thin as in the shaft that allows you to enter the lock.

[Jackpot]

its thin enough to fit in most locks... but there are still some like house locks... and some cabnet locks... i havent tried a master lock yet... but do bike spokes fit in most locks that are made or are they to big and must be grinded down to fit?

[Pheniox]

they would fit most locks i assume.

[Jackpot]

ok i make my stuff at school... at schools we have mills and lathes... would a lathe work on trying to make it thinner do you think so we could make it thinner to fit into more locks... and how would i bend the end of the flat peace for the pressure wrench... would i heat it with a torch or just use a hammer and an anvil and tap it to the side...