Australian mn triton remote key.

[Billythelid]

Is Sbb pro2 able to read pin code from Australian mn triton. It says Australian 99+ year but seems to throw ECU not connected.

What machine will do a Aussie mn triton. I have transponder key (not remote).

[Squelchtone]

Is Sbb pro2 able to read pin code from Australian mn triton. It says Australian 99+ year but seems to throw ECU not connected.

What machine will do a Aussie mn triton. I have transponder key (not remote).

I do see that the SBB claims to do:
TRITON[PIN1] 99-
TRITON[PIN2] 99-

What problem are you trying to solve? Are you wanting to add a new transponder key to this car? Do you have another already working key that is matched to this car?

Have you looked at the option of using some programming instructions to join that key to the car?

Have a go with these instructions *IF* you have 2 working transponder keys that are linked to this car already:

I found this on the web:
How to program Mitsubishi transponder chip keys 2002-up Mitsubishi vehicles
I am no way responsible of any damages that may occur during the procedure of programming your transponder chip keys. You are doing this at your own risk. If you do not feel confident to following the procedure I strongly recommend going to your closest Mitsubishi dealer and have the key(s) programmed there

You can program new keys to the system if you have two valid (already registered) keys by doing the following

1. Insert the first valid key into the ignition and turn the ignition
to the "ON" position for 5 seconds.

2. Turn the ignition to the "OFF" position and remove the first key.

3. Insert the second valid key and switch the ignition to the "ON"
position within 7 seconds. Theft-alarm indicator will blink twice.
Turn the ignition to the "OFF" position and remove the second
key.

4. Insert a blank (transponder) key, specially cut for your vehicle
into the ignition and switch the ignition to the "ON" position
within 7 seconds.
The theft-alarm indicator will come on for about 3 seconds when
the registration is completed.
If an error occurs, the indicator will blink 3 times.

5. If you want to register additional keys, repeat step 4 within 30
seconds after the theft-alarm indicator flashes in step 3.

Note:
You are provided with 2 keys, but you may add up to 6 more keys.


Hope this helps,
Squelchtone

[Billythelid]

Sbb says ECU not connected for both these.
It's preferred to get ECU reset to new keys because keys where stolen. Also means only one transponder, not remote key.