Remove cylinder from padlock

[orjan]

I have been searching on the forum for a guide on removing the cylinder on a padlock, but could not find one by searching. This is the lock im trying to remove the cylinder from.(i can post a better picture if needed)http://www.lasgruppen.no/Felles/images/Ehengel.jpg

[p1ckf1sh]

I have been searching on the forum for a guide on removing the cylinder on a padlock, but could not find one by searching. This is the lock im trying to remove the cylinder from.(i can post a better picture if needed)http://www.lasgruppen.no/Felles/images/Ehengel.jpg

I can't really make out enough to give you a guide, but I would open up the lock, and take a look into the hole where the shackle is pushed into. There might be a screw in there. I have two padlocks that can spill the cylinder like this, but they are completely different (ZeissIkon, cylinder almost euro-shaped). Other than that - no idea.

One more thing, you should be careful when removing the cylinder. Getting the thing back in (placing the springs and pins etc) will probably be pain in the middle part of the body, rear-side. You will have to make yourself some clever mounting clamp I suppose.

[elliot paxton 11]

I can’t make much out from the picture....
If there is anything else about the lock that you could tell us that would be great,Who made it and so on.

[orjan]

The lock is a Trioving 5652(norwegian), FG class 2, 7 pin with some security pins. There is a unbraco as shown on the new picture, thats the only thing there is that can be removed, i have tryed to remove the unbraco with the lock opened, but it will only get 2-3 mm out and then its stuck. http://www.stranda.org/5652.jpg