key decoder

[NIC]

i've been playing around with a Schlage mortise cylinder.I took out the pins, and now i would like to know what numbers are the pins?? I don't have a key decoder !!Can any one point out to me where i can find the measuments 0-9, yes i have a caliper!!

thanks you !!

[JackNco]

Code: Select all

SCHLAGE

SHOULDER TO FIRST CUT:  .231''
CENTER TO CENTER:  .156''

MACS:  7

     ROOT    BOTTOM    MASTER
     DEPTH   PINS      PINS
     -----   ------    ------
# 0  .335    .165
# 1  .320    .180
# 2  .305    .195      .030
# 3  .290    .210
# 4  .275    .225      .060
# 5  .260    .240
# 6  .245    .255      .090
# 7  .230    .270
# 8  .215    .285      .120
# 9  .200    .300

Hope this helps

[JackNco]

ok thats a bit out of shape, post it in notepad and it will look right

[NIC]

Thank you Jack !!

[Shrub]

ok thats a bit out of shape, post it in notepad and it will look right

[JackNco]

Cheers Shrub

[WOT]

Code: Select all

SCHLAGE

SHOULDER TO FIRST CUT:  .231''
CENTER TO CENTER:  .156''

MACS:  7

     ROOT    BOTTOM    MASTER
     DEPTH   PINS      PINS
     -----   ------    ------
# 0  .335    .165
# 1  .320    .180
# 2  .305    .195      .030
# 3  .290    .210
# 4  .275    .225      .060
# 5  .260    .240
# 6  .245    .255      .090
# 7  .230    .270
# 8  .215    .285      .120
# 9  .200    .300

Hope this helps

Factory service manual shows the existence of odd numbered master pins for Schlage. This is for Everest Primus, but it says the bitting specs is the same as classic (with the exception of the presence of side bitting).
I wonder where whoever made that table came up w/ the idea about the lack of odd numbered mater kins.