Master No. 130

[dmux]

well i found a cut master 130 today and i was trying to pick it and it just opened and they plug didn't even turn, i noticed that when i stick a hook pick in the very back and apply tension with a tension wrench, the lock will open right up, you have to do the same type of motion as the american bypass tool,

i would make a video and put it on youtube, buy my current address and internet connection limit that capability

[Kaotik]

In that case you could probably open it with the straight edge of a knife tool because the pins are virtually the same length.

Have you thought about or taken it apart for further investigation?

[Iceberg_Slim]

i would also like to add 100% to check out the bible and the pin stacks and see if something is broken. also could be a problem with the schackle itsself

[udanis]

I can do the same thing with my 130. The 130 is a low tolerance lock so you are able to do that.

[udanis]

Being that there is only one shackle "leg" going into the lock you might be bypassing that. (but shh we aren't allowed to talk about bypassing)