PLUG SPINNER-a richman's garbage is a poorman's treasure

[yono]

Most of us has the ability to piece together what interest us in our mind. the determination to put it together is an asset to anyone. here is one of the ptoduct of my interest. The plug spinner all from a materials that seem useless for most. (all from a damage locks)
1.Sargent mortise handle--retaining nut(modified) 2pcs
2.Medeco cam lock- threaded extension T-rod 1pc.
3.Profile cylinder- thumbturn 1pc.
4.Von duprin panic bar- coupling 1pc
5.Weiser knob- outer rose spring 1pc
6.Aluminum pen light- housing 1pc
7.Hacksaw blade-fabricate to spinner blade 1pc
8.Medeco set screw- 2pcs.
http://i302.photobucket.com/albums/nn11 ... 040727.jpg

[Legion303]

That is some very nice work.

-steve

[sir locksalot]

looks good, is it a screw then release mechanism?

[yono]

The bottom one is the first been made The one with a T-handle yes its a screw hold and release function. The second one with a round handle is and improved one. the handle is the engage and disengage release part. thanks for asking.

[dyess002]

Very nice peice of work

[Jeckel]

Wow that looks really nice. Looks like something that you would buy retail.

[yono]

to those who are planning to make their own P.spinner, Here i will show you a simple self explained picture for your additional info.
Note: you dont need to let it look the same,but let it be same as effective.
*1. you can use a 12cm long x .6cm bolt with two nutts
*2. a counterclocwise coil spring (a little bit bigger in radius with your bolt
dia.
*3. A pipe for it housing
YOUR COMMON NEEDED SHOP TOOLS
**Electric drill, 1.5mm drill bit, vice clamp,Hacksaw,Hammer,Hand piles,
vise grip plier.
http://i302.photobucket.com/albums/nn11 ... 040810.jpg

goodluck