Fogmeister wrote:Hi guys,
I just wanted to know if it's possible to disassemble a lock I have and repin it?
[...]
It's a 5 pin lock and I have the key for it. I wanted it to practise on it and I wondered if the only way to repin this is to "Dremel" the "caps" that hold the pins in?
You got the link to the guides. On a side note, if this lock is just for training and you don't mind butchering it and you are not interested in the coupling/cam mechanism you can simplify the repinning by just cutting the lock in half right where the cam/screwhole is. This way you get two halves and it is easier to repin the lock with proper access from the rear. You don't have to fiddle around with mounting clamps that way, you can just use a plug follower to push out the plug and vice versa for reassembly.
Certainly easier if you are new to pinning. At least it worked for me

. I only have halflocks without cam for training...
Due to financial limitations the light at the end of tunnel has been turned off until further notice.