need key by code cuts

[copeman]

i am at work and need someone with a code program other than codesource to run the code (n25) please.

Blank: y11
cuts: should be four
goes to: desk


thanks copeman

[greyman]

I had a look on genericode but couln't find a Y11 blank. What's it for?

[linty]

y11 is the same thing as n54G or pundra, etc.

i see it as a hudson 5 wafer

looks like 71733, but what kind of depth and spacing data are you looking for?

for hudson 5 wafer if i remember right 7 is shallow, 1 is deeper, and 3 is deepest.

[copeman]

thanks guys i will give it a shot

[mojomojo]

Hey Copeman did you ever get that key to work......I hate doing file cabinet and desk locks.....Y11 to me is like a semi-universal b/c many keyways are built around it....Try ilco cg16 on codesource or na14 i believe....another method I used is depending on the type of lock I will pick it open than remove the cylinder in which then I then decode the wafers with my punch!!!!!!!!!!! the space and depth are minimal and they are very tolorent to half cuts!!!!!!!! Just my worthless 2 cents

[copeman]

well i got it cut just fine and i would have impressioned it except it was a walk in and they couldnt bring the lock to me, otherwise i just take a half ball rake it till the plug comes out of the cylinder and decode it or if it doesnt come out i will just impression it


thanks again copeman