peterson pry bar lite

[dmux]

does anyone have this tool? it is a little thinner than their original prybar

[Eyes_Only]

Just a .010 difference? Hmm...doesn't seem to be much of a difference from the original Pry Bar to give me enough reason to buy it. I think if you have the original Pry Bar and the Flat 5 set you'll be ok. Although our European friends might find good use for it.

[JackNco]

huh thats a new one, but at that price it would be rude not to get one next time i do an order with them. I find the original 2 thick my self.

John

[blake1803]

I agree with Eyes_Only: the main appeal of the original Pry Bar is its thickness... and for everything else the flat 5 tools are more than adequate...

but I ALSO agree with John: I'm sure it will be in my next Peterson order nonetheless

[Eyes_Only]

I actually want one too to be honest but my pick set is so jam packed already that I'm gonna end up ripping my beautiful Peterson case if I add anything more.

[JackNco]

if you have a tri fold i just keep a few tensioners in the middle section with the flap over them. there safe enough once the then is all cosed up.

But yes i can see a couple of edges going on mine from being over stretched.

John

[rwp42]

My Peterson case is also bulging... I added the flat-5, a set of double-sided picks, and both two-prong tension wrenches, and there really isn't room for anything more. My peterson plug spinner just arrived -- has anyone found room in their case for it, or do you just keep it separate?

RwP