Problem with door lock cylinder

[elite]

Hello guys, I'm picking a standard door lock cylider, similar to this one, with 5 pins

The problem is, when I picked the lock from one side, and I turned it to 180 degrees, the lock became locked again, and I can't turn it left or right.

From the other side of the cylinder, the lock still works, but from the "broken" one, the pins move freely inside the lock, and I can't put the key in, or turn it back to normal. I don't know if I explain the problem good enough, I hope you can understand me, just the pins move freely and I can't insert the key to bring it back to normal (turn it 180 degrees). I tried using the pick and the tension wrench too, but nothing.

Any fixes?

[elite]

I repaired it with the tension wrench from the side where the pins get into the cylinder, they must have been sticking out. If you want, you can delete this topic, I found it's been discussed.