Drilling Locks

[max1002]

Hello all!
I'm brand new here so please forgive me if I'm posting this in the wrong area. I just recently acquired a [REDACTED] and tested it out the other day on a Best SFIC and an old Sargent I had laying around. The problem I encountered was the bit breaking on both after hitting just the first or second pin stack. These are the heavy duty bits mind you, that run $40 each! What am I doing wrong? I followed the directions [REDACTED] just as instructed. Any help would be greatly appreciated.

Thanks,
M-

[femurat]

Hello and welcome to the forum.

We pick locks as a hobby and don't talk about destructive entry technique. At least not in the open forum.
See rule 19 viewtopic.php?f=2&t=715

I'm locking the thread