DIY Lockpick Stand?

[Jacob Morgan]

Made this last Saturday. Used some scrap 3/4" cedar. Used a back saw and chisel to make a dado joint in the bottom board. Used the closest hole saw that I had for the cylinders. Drilled in the side with a #19 drill bit then screwed in stove bolts to hold the cylinders in place.

Should have made a place for profile cylinders, but did not think about it at the time.

[greengrowlocks]

Very nice stand GGL. I made some very simular stands out of some pieces of maple from my burn pile last week. I posted a pic of them already in the "what about cases" thread.

Aww sh*t I should have probably posted in that thread. I saw the OP's title and thought it was fitting however it seems he is asking more about a cylinder stand. Nice work man I like the solid wood look.

GGL

[mattc]

An old picture, the rear board is gone as I streamlined my lock collection but I think you get the idea.

[Ralph_Goodman]

An old picture, the rear board is gone as I streamlined my lock collection but I think you get the idea.

The handle on the one in the back is pretty genius. I almost missed it too. Very cool idea.