Drive/Bolt Cam Needed

[djed]

Does anyone have a drive/bolt cam they are willing to part with? This is the cam that moves the bolt work on an old Mosler safe. The one I have was drilled. Thanks in advance.

[djed]

[00247]

Without a picture of it in an assembled state, I am not sure how much is missing off the end. It probably isn't much. I would rebuild the part you have. It is cast so a competent weld shop can build it up with nickel rod/wire and you can shape it to the required need. A spray weld process would be ideal.

[MartinHewitt]

Or just hard solder with solver solder a piece of steel to it. That should be pretty durable.

[djed]

I’d think the repair would have to be VERY strong since if it breaks the handle turns and the safe opens.

[djed]

I hope these pictures help:

[capt.dunc]

silver solder a new piece on, there's loads of space to make a new bit which can have a large contact area and pin through as well on to the cam without getting in the way of operation.