Double sided Bogota -WIP

[streak]

I was planning on making two at once and then cutting in the middle.
However I like the look of the double sided one.
I already have a few single ones.
I am still busy polishing it up and removing remnants of the glue I used to secure the grip.

[stratmando]

Do you use Heat Shrink Tubing with the adhesive?
What is distance of the peaks, giving thought, I feel the distance between the peaks should be 2 depths of the lock you are working with(distance between pin 1 and 3 for example) this way, when pick is inserted, one peak is between pin 1 and 2, other, between 3 and 4(4 pin lock).
Pushing pick in, 1 and 3 is raised, allowing 2 an 4 to drop.
And Vice Versa
A 7 pin lock would need 4 peaks.
Any thoughts on this, Thanks

[streak]

I am really no expert. I printed out a template that I used to make these. So far they work very well on a number of my test locks.
Distance between peaks is about 6.5-7mm
I use gutted 550 paracord covered in heat-shrink tubing as the handle. If I don't use a but of superglue then the handle tends to slide a little.
I put a few drops at each end of the paracord and some in the middle before sliding the heatshrink over and shrinking it down.