X1054JK needed

[Peter Martin]

These key blanks are really expensive. Around $3 each in small lots (10 or less), plus s/h which doubles cost.
These keys fit old ILCO "peanut cylinder" padlocks, and I am impressioning one.
Taylor lists a cross reference to an IL13, but that is a thicker and longer key blank.
Anyone have a source for these that is reasonable?
Pete
Sioux Falls, SD

[GWiens2001]

Have a picture of the keyway? I think I know which one it is, and may be able to help.

Gordon

[Peter Martin]

This is a pic of the keyway. I thought maybe X1054BK would also work. I haven't tried that though.
I definitely know the X1054JK will fit.

[Raymond]

Have you tried a Kwikset?

[GWiens2001]

Unfortunately, I don't have that blanks for that section. Sorry. Hope someone else can help.

Gordon

[Peter Martin]

Kwikset KW1 is entirely too large (tall) and not the same profile.
An ILCO X1054BK may operate, but the taller ILCO X1054K will not.

I will bite the bullet and buy a few online from the lowest price I can find... and hopefully don't screw up too maany blanks before I get a working key impressioned.

Pete

[Peter Martin]

I found the discontinued blank number... which is helpful when trying to buy vintage discontinued stock.

[billdeserthills]

I found some X1054JA blanks in my shop that look pretty close--I think that's what I used to make a key for my Ilco padlock too

[RubberBanned]

I have some of those blanks.

[Peter Martin]

I have some of those blanks.

Thanks. I pM'd you.
Pete

[stratmando]

To increase your odds of success and you can pick open, you may be able to determine depth of pin 1, and if second cut is deeper, you might get pin 2's depth. Good luck.

[DaWolfMan]

Peter Martin,

I found them here for you, they are $1.58 each.

That is the best price i found so far unless someone has some NOS sitting around.

https://securitylocking.com/dormakaba-x1054jk-ilco-key

DaWolfMan