|
Forgot how to dial the combination on that old safe? Think you got the right numbers but the handle is stuck? What safe should you buy? Ask your safe questions here!
Forum rules
You are posting this in This Old Safe, a public area of the forum.
Safe manipulation discussion is allowed, but safe drilling or other destructive entry is only allowed in the Advanced - Safes and Safe Locks area.
If you are a guest of the forum and have a safe you need to open, but you do not have the combination, we cannot tell you how or where to drill it.
 by oceanservice » 13 May 2021 2:52
Found this post linked in a more recent thread, and it's very nice. Thank you for putting the time in to make it! I'm trying to better understand how/when I'm picking up each wheel rather than just following written directions so this is nice
-
oceanservice
-
- Posts: 12
- Joined: 15 Jun 2014 12:48
- Location: South Florida
by Joe V » 1 Jan 2022 20:56
No one drills the lock bolt in the location of the ball detent in the lock. It is there so the bolt comes back to the same position each time the lock is locked backup so the lever doesn't hang up on the lever stop causing lockout problems.
-
Joe V
-
- Posts: 8
- Joined: 1 Jan 2022 12:11
Return to This Old Safe
Who is online
Users browsing this forum: No registered users and 1 guest
|
