Did I make a mistake when I assembled my S&G 6730?

[amo]

Thank you your comprehensive response. I tried a bit more force to get the key to turn. I think so probably could turn it but I see that the key is gouging the keyhole in the case cover.

Maybe that's how it's supposed to be but it would seem odd to normally expect the little bits of the case cover to get scraped of and fall inside the lock body.

I'm away out if town now for a couple of weeks but when I return I'll examin the key to see if it sustained damage while cutting into the case lid. I suspect the key is harder than the case so the best course may be to go ahead and force the key to turn and ream out enough of the keyhole in the cover, (with the cover removed so the metal dosnt fall into the works).

Again, though, the interference is occurring between the key and the cover -- it has nothing to do with the wheels, etc., inside the case.

[GWiens2001]

In that case, when you get back to the lock in a couple of weeks, take off the back cover, put the change key through the hole to the correct depth, and then see if it turns freely, without any resistance. (While the back cover is not on the lock at all). This is to see if for any reason the key or back cover have issues.


Enjoy your 2 week trip.

Gordon

[Raymond]

Measure the diameter of the change key where it contacts the back cover. Using the closest , but larger, drill bit, drill out the center of the change key hole on the back cover. Leave the change key uncut.

[GWiens2001]

Measure the diameter of the change key where it contacts the back cover. Using the closest , but larger, drill bit, drill out the center of the change key hole on the back cover. Leave the change key uncut.

Hold off on that until you know whether or not the change key can move freely inside the change key hole on the back cover BEFORE drilling the back cover. I am trying to find out if the problem is with the back cover, key, or that the wheels are lining up properly first. It would be unfortunate to drill a hole in the back cover (voiding the warranty) only to find out that the bottom wheel if not properly lined up and not allowing the change key to fully insert, therefore having the flag on the key blocking the key from turning.

Gordon

[Raymond]

Thanks. Agreed. I presumed that that had already been established. I have found a few change keys to be tight the first time or two and was just trying to hurry up his conclusions. I don't believe anyone has mentioned that the point of the change key will stabilize in the hole in the bottom of the lock case either. Actually, I would probably just use a very gradually sharpened ice pick to gently form the hole in the cover. We will know more when he gets back.

[Squelchtone]

This has not been posted yet, but you may find this factory installation video informative.

https://www.youtube.com/watch?v=mjmLG8tNfWQ


Good luck,
Squelchtone