by Chubby » 18 Feb 2004 17:22
As you are already familiar with Multipick-services, I take it your talking about the Glocke, it will also pull the entire cylinder out if required, it has two special plates you use with it to pull just the plug (Profile or round cylinder locks) either method is not destructive, at least not to the lock the profile cylinder is installed in.
You will also need pulling screws, and I would recommend a universal short key to open the lock with once the job is done, last but not least, the screws are Torx screws size 20, you can either use a T handled driver or also purchase from MPS the drill bit adaptor.
As for is it worth it, I think it is well worth it, and the feed back I have had from others that have purchased one all agree. The biggest suprise is how smooth it actually works, the pins and side retaining pins may have well have been made of cheese it is so smooth, no noise no fuss, if anything it's underated.
Support your local locksmith -- lose a key. Support your local institutional locksmith -- lose a master key.
