I was bored as we were driving up to our vacation destination, so I pulled out some stuff and made a snapgun from one of those click-pens. After I got home I went and opened some locks, and it works allright.
What you need:
1 click pen
picks that can fit the ink tube
WHat to do:
1. Take the pen and open it up. Take out the ink tube and cut off the tip about a 1/2 cm above the ball pen.
2. Slit the tube both sides about a half cm
3. Assemble whats left minus the cap.
4. Take a pick and put the cap over it
5. Slide the pick into the tube as far as you can get it.
6. Screw in the cap
7. Use
This is pretty cool. Just put the pick by the pin you want to set and click it a couple of times while applying the usual torque. THe only problem is getting picks that thin. I found its hard to use soft small diameter wire. My suggestion (and what I did) was to take the bought kind with handles and simply file the handle away so the extended tang fits snugly in the ink tube.
Happy pickings