Okay This is How it's Done!
1.) Cuss out the padlock
2.) Flip off the padlock
3.) Remove the Allen screw from the back of the lock (3/32")
4.) Make sure the padlock is locked pore Marvel Mystery Oil in the hole where the Allen screw was
5.) Grab a 2lb rubber mallet (the bigger the better)
6.) Beat the living crap out of the padlock to remove the shackle retaining pin
7.) Remove the shackle and spring
8.) Remove the shackle heal ball bearing.
9.) Grab a magnet (pen or needle type)
10.) Insert the magnet in the heal shackle hole.
11.) Pull out the bottom plate keeper pin
12.) Slide out the bottom access plate
13.) Remove the lock assembly core
14.) Remove the actuator
15.) Remove the toe ball barring
16.) Flip the lock off again and tell it "What's up now Mother F$#Ker!"
Note: The bottom access plate and lock core are in the reverse order in the picture...
