ive been doing alot of research on how to pick locks lately because i think this looks very interesting
Good, research is good....
all i was wondering is why wouldnt a uncut key open up a lock?? it pushes all the pins up. i know it wouldnt work, im just curious to know why?

*sigh* Research didn't work....

things called shear lines. Basically, the whole POINT of a lock is to have a mechanism that can only be opened with a certain key. The reason this certain key opens the lock is because it has the correct tumbler combination cut into the blade. If a blank could open a lock, then why have a lock in the first place? Why bother cutting this magic blank if it opens all locks?
*sigh again* Tumblers must be raised to the correct height to allow the rotation of the plug. Whether it be pins, wafers, whatever, they must be at the correct height (the shear line) or else they will get stuck in the shell and the plug will not rotate, hence not opening the lock.
I know you're new, so I didn't want to flame you too bad, but please..... PLEASE

, research some more, read the FAQ section and take it all in.
P.S. When in doubt..... use thermite.....
